threadsizes

UNEF thread chart: extra fine

The UNEF (Unified Extra Fine) series of ASME B1.1 covers the finest standard inch threads, from #12-32 up to 15/16-20. Thin-wall tubing, instrument work and the muzzle and accessory threads on sporting goods use them. Read across: the thread, the drill to tap it, the drill's size in inches and millimeters, how much of a full thread it leaves, and the class 2B minor diameter limits. The drill is the one closest to the 75%-thread target tap makers design for.

New to screw sizes? Screw sizes explained covers how to read #8-32 x 1/2 and M6 x 1.0 x 20.

UNEF extra fine threads (ASME B1.1)
ThreadTap drillInchmm%Minor dia. 2BClear.
#12-32 pending* 0.1822–0.1896 –
1/4-32 7/32" 0.21885.56 mm 5.56 77% 0.2162–0.2236 9/32" 0.281
5/16-32 9/32" 0.28137.14 mm 7.14 77% 0.2787–0.2861 11/32" 0.344
3/8-32 11/32" 0.34388.73 mm 8.73 77% 0.3412–0.3486 13/32" 0.406
7/16-28 Y 0.404010.26 mm 10.26 72% 0.3988–0.4073 15/32" 0.469
1/2-28 15/32" 0.468811.91 mm 11.91 67% 0.4613–0.4698 9/16" 0.562
9/16-24 33/64" 0.515613.10 mm 13.10 87% 0.5174–0.5271 –
5/8-24 37/64" 0.578114.69 mm 14.69 87% 0.5799–0.5896 11/16" 0.688
11/16-24 41/64" 0.640616.27 mm 16.27 87% 0.6424–0.6521 –
3/4-20 45/64" 0.703117.86 mm 17.86 72% 0.6959–0.7074 13/16" 0.812
13/16-20 49/64" 0.765619.45 mm 19.45 72% 0.7584–0.7699 –
7/8-20 53/64" 0.828121.04 mm 21.04 72% 0.8209–0.8324 15/16" 0.938
15/16-20 57/64" 0.890622.62 mm 22.62 72% 0.8834–0.8949 –

* Drill left blank until enough published sources agree. The thread data is in the calculator. Have a chart that lists it? Send a source.

UNEF is the ASME B1.1 extra fine series: more threads per inch than UNF at the same diameter, which gives finer adjustment and shallower engagement. Common uses include thin-wall nuts and sleeves, bezel rings, instrument spindles, and the 1/2-28 and 5/8-24 threads on firearm barrels and muzzle accessories. For general shop work prefer UNC or UNF — UNEF taps and dies are a special order. Clearance is the ASME B18.2.8 normal fit. Minor dia. 2B is the smallest and largest hole the finished internal thread may have (ASME B1.1, class 2B). Thread percentage is the tap makers' convention (the formula is on standards); it is not a percentage of strength.