threadsizes

License plate screw size by make

The screw that holds a plate on depends on the car, and sometimes on the model year. This table is kept by readers: each row says how it is backed, by published parts listings or by people who checked their own car, and you can confirm or dispute any row.

Updated October 11, 2026

License plate screws by make community table

MakeModels, yearsLicense plate screwIntoEvidenceRight for yours?
Ford Many models (Ford part N804376-S307, license bracket screw), 1991-2018 #14 (1/4-14) tapping screw x 5/8 in, hex washer headFord catalog: "M6.3X1.81X16.0". Kimball lists #14 x 5/8 for Ford N800369. Check your model in the catalog. 2 sources [1] [2]
Jeep Wrangler JK, JL; Gladiator JT, 2007 on 1/4-14 tapping screw x 3/4 in, hex flange head (2 per vehicle)Mopar 06034866: "Screw Tapping Hex Flange Head .250-14X.750". 2 sources [1] [2]
Add your car

Entries appear after a quick check. Other readers can confirm or dispute them.

How to find the size on your car

Take one screw out and look at what it goes into. If it threads into a metal nut or a threaded hole in the bumper, it is a machine screw: measure the diameter with calipers and check the pitch with a thread gauge, or compare it with a known screw. A metric screw is named by diameter and pitch (M6 x 1.0); an inch one by diameter and threads per inch (1/4-20). They can look alike, so check before forcing one into the other: see M6 x 1 and 1/4-20 for how close the two are.

Some parts catalogs write the common #14 plate screw as M6.3 x 1.81 (Ford's catalog does, for example). That is a 1/4 in tapping screw with 14 threads per inch, since 25.4 ÷ 14 = 1.81 mm, not a metric M6 x 1.0: the two will not swap.

If it goes into a plastic insert or grommet, it is a self-tapping screw that cuts its own thread in the plastic. There the insert matters as much as the screw: a new screw in a worn insert will not hold.

If the hole is stripped

A plastic insert is the easy case: pull it out and fit a new one of the same size. A stripped metal thread can sometimes be cleaned up by running a tap of the same size through it; if the thread is gone, it needs a thread insert or the next size up, drilled and tapped. The tap drill for each size is on its thread page, for example M6 x 1 or 1/4-20.

Frames and longer screws

A plate frame adds thickness, so the screw may need to be longer by about that much. A screw that is too long can bottom out in a blind hole, which feels tight while the plate is still loose, or reach parts behind the bumper. Add only what the frame adds.

Know your car's plate screw? Add it to the table. Corrections to existing rows: use the No button on the row.