threadsizes

Send a source

If you have a tap maker's chart, a fastener catalog, a handbook page or a copy of the standard that lists any of the values below, please send it. Charts that disagree with ours are just as welcome.

Wanted

ThreadValue
#12-32tap drill (we calculate #13)Send a source
M12 x 1.25tap drill (we calculate 10.8 mm)Send a source
M18 x 1.5tap drill (we calculate 16.5 mm)Send a source
#2 screwsclearance hole (close, normal, loose) (ASME B18.2.8)Send a source
#4 screwsclearance hole (close, normal, loose) (ASME B18.2.8)Send a source
#12 screwsclearance hole (close, normal, loose) (ASME B18.2.8)Send a source
7/16 screwsclearance hole (close, normal, loose) (ASME B18.2.8)Send a source
NPT, all sizestap drill when using a taper pipe reamerSend a source

Your source

We check every source by hand. Uploaded files stay private: we use them only to check the value and never publish them. Scans of standards you are not allowed to share are not needed: the standard's name, edition and table number are enough. See Standards for the standards the site is built on.